Laying Carpet Stones

How to lay carpet stones

Our useful how to lay Carpet Stones paving laying guide will give you all the information you need to install this beautiful paving products, if you choose to do-it-yourself.

Ensure you read our advice before beginning work on your new design project - this will mean you are fully prepared and have everything to hand, ready to complete your perfect garden.

Download our guide to laying Carpet Stones

Watch the video

Watch the video on How to lay Bradstone Carpet Stones by David Domoney

Step by step guide

All­in ballast, building and sharp sand is available from your stockist.

Carpet Stones patio

Laying carpet stones - dig foundations

STEP 1 Dig the foundations.You should go at least 150mm below the damp proof course, plus the thickness of the paving plus another 75mm. Ensure water cannot collect besides buildings by allowing a slight fall away to a convenient place.

 

 

Laying carpet stones - laying foundations

STEP 2: Cover the entire area with a semi­dry foundation mix of 6 parts sharp sand to 1 part cement. This should be 75mm deep. Compact and level the area. It is recommended that a maximum of 3m x 3m is levelled at any one time.

 

 

Laying carpet stones paving

STEP 3: Lay the Carpet Stones as required, making sure the joints are evenly spaced. Use a rubber mallet to ensure the stones are well bedded into the foundation. Alternatively, you can use a 75mm x 50mm piece of timber with the rubber mallet. Use a spirit level to ensure the paving is level.

For a more realistic look you can interlock the Cobble Carpet Stones by cutting the half blocks. The Random Carpet Stones are also designed to be interlocked by simply cutting out the centre stone and turning the cut pieces 90 ̊ to join the mats together.

 

Laying carpet stones - sharp sand finishing

STEP 4: After 24 hours, brush a mix of 4 parts sharp sand to 1 part cement into the joints. The mix should be dry enough not to leave stains on the surface of the stones. If you prefer, you can point the joints using a semi­dry mortar mix of 3 parts building sand to 1 part cement. Again, this mix should not be too wet or too dry.

For a more rustic effect you could simply lay on a 50mm bed of sharp sand and brush in more sand or sieved soil to fill the joints.

Find a local installer

Use current location

Where To Buy

Use current location